NORA knives BLOG

So we finally broke our tester M4 knife today. I was getting to...



So we finally broke our tester M4 knife today. I was getting to the point I was going to give up but thought maybe a 1/4in rod of steel with a 3lb dead blow might do it. And it did! Almost cut the steel tho. Not bad for a knife heat treated to 64hrc with a chef knife grind. I can’t tell you how many pennys we cut in half to show it off but I’m sure we are around at least a quarter maybe a nickel on top of that! Should last a long time in the kitchen. Plus with our lifetime no questions warranty your good to go.
#noraknives #handmade #chefknife #cheflife #kitchenknife #knifemaker #knivesofinstagram #tester